Related topics

Adding ST15150N SCSI drive to Sun 4/110 with MD21 controller ...
I did my most testings with a Quantum TM-2110S Fast-SCSI drive, partitioned into 5 partitions. But I have no MCS-700 or IBM Fast SCSI-2 controller. Whatever: the 700 is a Fast-SCSI controller, achieving a data transfer rate of 10MB/s ... the IBM SCSI with cache is only a SCSI-1 controller running at max. 5MB/s.

Question concerning SCSI controller...
Bottom> writes: Skaya wrote: Abdullah Ramazanoglu wrote: Hello, Think of a PCI or off-case disk controller card that that emulates some popular SCSI controller, and drives 7 or 15 EIDE disks (possibly UDMA) with only one IRQ line, DMA, and I/O range. I think that such a card, coupled with RAID-5 support in Linux,

Installation fails for Adaptec (AIC7880) SCSI Controller
If
I connect the ribbon cable of the scsi HD to the scsi HD controller AHA-2920 when I boot the PC says PRESS ANY KEY TO BOOT if I do so, it will not boot and ask over same. Tell your BIOS to boot from the IDE controller or reinstall windows on the SCSI drive. scott.

Dual Scsi Controller Question
Dave
Olson ol...@anchor.engr.sgi.com comp sys sgi hardware craca...@wavehh.hanse.de (Martin Cracauer) writes: I have a second (GIO-) SCSI-Controller in my Indy. I noticed that the same disk drive is slower when it is connected to this controller instead of the build-in. Even worse, accessing it consumes much more

SCSI Controller, HDs, Burner, CDROM and Cables
Warren Block wbl...@rapidnet.com comp sys amiga hardware Greg L. Kimnach (g...@betamax.fan) wrote: i recently installed a 4008 scsi controller in my g-force 040 combo'ed a2000. to the 4008 i planned to connect a 1gig empire hd and a jvc 2010 cdr. (i plan to move these two devices between my amy and "pc",

Best scsi controller for application...
Following
is a data file re; the MD21 that I typed-in circa 1990: EMULEX MD 21 ESDI to SCSI BRIDGE CONTROLLER The following is from the MD21/S2 DISK CONTROLLER TECHNICAL MANUAL, Part No. MD2151003-00 Rev E, March, 1988, available from Emulex at 1-800-854-7112 for approximately $25. They do not operate a BBS.

new SCSI controller name?
Originally there were external Drives to the on-board controller connected. We didn't got these external drives, but installed three new inside (4,5/18/18GB). The server has an dual processor motherboard (SuperMicro SLD3) with an IDE and a SCSI-Controller (Adaptec xxxx) on board.

Internal modem/SCSI controller conflict
"Leif Neland" le...@neland.dk mailing freebsd scsi ----- Original Message ----- From: "Justin T. Gibbs" <gi...@scsiguy.com> To: "Leif Neland" <le...@neland.dk>; <freebsd-s...@freebsd.org> Sent: Wednesday, January 22, 2003 12:19 AM Subject: Re: Adaptec 19160 SCSI controller configuration error: 02 But does that make

Want to change Adaptec to Mylex SCSI Controller without ...
Deep...@ix.netcom.com alt iomega zip jazz jsoo...@netcom.com (John Soo-Hoo) wrote: Yesterday, I connected my ZIP drive to SCSI controller supplied by ZIP. No problem, it works fine. But now I have a SCSI CDROM I want to attach to the SCSI chain (NEC 4V Multispin CDR-222). I visited the NEC ftp site and found that

Replace SCSI controller in winnt
Caveat Emptor Controller Micro Channel SCSI Adapter with Cache Implementation Planar/card - old PS/2's Option (Options by IBMä) SCSI type SCSI-1 SCSI bus pah / speed 8 bit / 5 MB/sec I/O Architecture Micro Channel I/O bus path / speed 16 bit / 3 MB/sec I/O features N/A RAID levels None (use software) Tagged Command

SCSI controller driver problem
Mario
ma...@flashnet.it microsoft public win98 setup Hello, I newly installed a win98 se, pentium I 133Mhz, 32 mega RAM with an IDE 2 Giga primary boot drive and a scsi drive 1.3 giga with an adaptec AHA-2920 controller. It all works fine, but as soon as I connect the ribbon cable of the scsi HD to the AHA-2920

Survey: Performance of Fast and Wide SCSI controller under Sun's
Ken Rogers ksrog...@erols.com comp periphs scsi Pat Cassidy wrote: I think I might be in the market for a new SCSI controller. My current controller is a Corporate Systems Center Fast/Wide based on the NCR/symbios 810 chip. I'd appreciate suggestions for what controller would suit my needs without wasting money on

SCSI-emulating EIDE controller exists?
Only problem is I have a 4091 scsi card and Cyberstorm PPC scsi controller on board.So I have no need for the slow motherboard scsi(Which I was told was the terrible slow 2091 controller built on the motherboard.Why I want to disable it is the machine has a slow boot up as it's looking for a scsi device on the

if I connect scsi HD to scsi controller while boot asks PRESS ...
Hi all, I have an indy with 24bit graphics and the standard SCSI controller. I have the need to have more scsi devices attached to it than what the standard scsi controller supports. I thought you could expand this by adding an additional GIO-SCSI controller. Is this true ? If so, where can I get one from ?

Best scsi controller for application...
The build went fine .... processor (p2 450), motherboard (p2b), memory (kingston pc100 sdram), video (pci stb v4400 tnt), floppy (teac), case (inwin w/235 watt PS), and bt-958 buslogic scsi controller and seagate barracuda scsi hard drive. I had no problem setting this up and formatting the hd and installing dos

need help to get scsi controller card working
Syed Zaeem Hosain s...@zcon.com alt cd-rom In article 245hb5INN...@umbc4.umbc.edu, syd...@umbc.edu (Mr. Sydney Cousins) writes: I want to buy a Toshiba XM-3401B internal CD-ROM drive only I don't currently have a scsi controller. Since I was planning to buy two new hard drives anyway I fiqured I might as well get

SCSI HELP!
0078 1 Controller - SCSI Riad by DPT - Model No: PM3334UW. supports Ultra Wide drives - appears New in box with manual and software . Model No: 150 16MB Ultra2 SCSI Card. New in box. 0219 1 Controller - SCSI Raid by DPT Smart Cache IV model PM2044U - Ultra 50pin PCI scsi Controller with RC 4040 raid caching

Which SCSI Drive Will Be Which?
Hello, I newly installed a win98 se, pentium I 133Mhz, 32 mega RAM with an IDE 2 Giga primary boot drive and a scsi drive 1.3 giga with an adaptec AHA-2920 controller. It all works fine, but as soon as I connect the ribbon cable of the scsi HD to the AHA-2920 controller and reboot: after the line: scanning

Multiple SCSI controller cards
hac hchristel...@home.com comp os linux hardware comp os linux setup comp os ms-windows setup win95 Gary Dale wrote: I have an old PAS-16 sound card with a built-in SCSI controller (made by Trantor) that I have connected to an old NEC-84 CD-ROM reader. This works when I use the old DOS drivers and MSCDEX but when I

scsi controller ? (obsolete ISA type)
John Soo-Hoo jsoo...@netcom.com alt iomega zip jazz Yesterday, I connected my ZIP drive to SCSI controller supplied by ZIP. No problem, it works fine. But now I have a SCSI CDROM I want to attach to the SCSI chain (NEC 4V Multispin CDR-222). I visited the NEC ftp site and found that the cdrom drivers are dependant